amax-2240 series 4-axis amonet motion slave modules ? max. 20 mbps transfer rate ? max. 6.5 mhz, 4-axis pulse output ? 28 bits counter for incremental encoder ? 2 ~ 4-axis linear interpolation ? 2-axis circular interpolation ? t-curve and s-curve velocity profles support ? change speed on-the-fy ? easy installation with rj45 phone jack and led diagnostic ? easy installation for servo or stepping motor driver ? suitable for din-rail mounting specifcations pulse type motion control ? motor driver support pulse-type servo ? number of axis 4 ? interpolation linear and circular ? max. output speed 6.5 mpps ? step count range 134, 217, 728 ? pulse output type out/dir, cw/ccw, a/b phase ? position counter 134, 217, 728 ? home modes 13 ? velocity profles t-curve, s-curve ? local i/o machine interfaces: el+ x 4, el- x 4, org x 4, sd x 4 servo driver interfaces: alm x 4, rdy x 4, svon x 4, inp x 4, erc x 4 position compare i/o: ltc x 4, cmp x 4 encoder interface ? input type a/b phase, cw/ccw ? counts per enc. cycle x1, x2, x4 (ab phase only) ? input range compatible with tia/eia-422 differential line driver i : 20 ma, vod : 2 v/min ? isolation protection 2,500 v rms ? max. input frequency 2 mhz @ 5 v general ? bus type amonet rs-485 ? certifcation ce, fcc class a ? connectors amax-2242/j2s: 2 x rj45 and 8 x 20-pin scsi amax-2241/pma & amax-2243/ys2: 4 x 50-pin scsi ? dimensions (l x w x h) 125 x 47.6 x 151 mm (4.9" x 1.8" x 5.9") ? power consumption 5 w @ 24 v typical ? power input 24 v dc within 200 mv ripple ? humidity 5 ~ 95% rh, non-condensing (iec 60068-2-3) ? operating temperature 0 ~ 60c (32 ~ 140f) ordering information ? amax-2241/pma-ae 4-axis amonet motion module for panasonic minas a ? amax-2242/j2s-ae 4-axis amonet motion module for mitsubishi mr-j2s ? amax-2243/ys2-ae 4-axis amonet motion module for yaskawa sigma-ii accessories ? pcl-10220m-2e 20-pin scsi cable, 2 m (for amax-2242/j2s) ? pcl-10150m-2e 50-pin scsi cable, 2 m (for amax-2241/pma and amax-2243/ys2) ? adam-3940-ae 40-pin flat cable wiring board with led introduction amax-2240 series is used to increase the number of axes for an amonet rs-485 decentralized motion control network. these extension slave modules connect serially by a simple and affordable cat.5 lan cable, reducing the wiring between driver and controller. this is very suitable for highly integrated machine automation applications. please select cable 20-pin scsi and plug this cable into the motor driver and motion slave module. amax-2241 amax-2243 amax-2242 rohs compliant 2002/95/ec www.advantech.com/products online download features all product specifications are subject to change without notice last updated : 19-mar-2014
|
